10x16 Sintered Bronze Bushing, ISO 2795
For a 10 mm shaft in a 16 mm housing bore, this 10x16 sintered bronze bushing (ISO 2795) presses in and runs on the oil in its sintered wall. Modeled as 3 lengths from 8 to 16 mm, each as simplified STEP.

How these parts are made, and what the levels mean: read the method
- Also known as: 10x16 oilite bushing, 10x16 sleeve bearing, 10x16 plain bearing, 10x16 self-lubricating bush, 10x16 x 8 to 10x16 x 16
- Model id:
iso2795-c-10x16
- Standard: ISO 2795:2020 · size 10x16
Lengths
| Length (mm) | Part key | Simplified |
|---|
| 8 | iso2795-c-10x16x8 | STEP |
| 10 | iso2795-c-10x16x10 | STEP |
| 16 | iso2795-c-10x16x16 | STEP |
Dimensions

| Symbol | Name | min | nom | max | Modeled | Rule | Level |
|---|
| d | Inside diameter | | 10 | | 10 | nominal | L2 |
| D | Outside diameter | | 16 | | 16 | nominal | L2 |
| C | Chamfer, maximum | | | 0.4 | 0.4 | single limit (max), modeled at the limit | L2 |
| C_angle | Chamfer angle | | 45 | | 45 | nominal | L1 |
Drawing

As a PDF: CC-ISO2795-SZ-10x16.pdf.
The 10x16 sintered bronze bushing beside the 9x12 and the 10x14
The 10x16 is number 17 of the 20 ISO 2795 sintered bronze bushings published here, listed from 2x5 to 12x16.
- Inside diameter (d): 10 mm on the 10x16 sintered bronze bushing, against 9 mm on the 9x12 and 10 mm on the 10x14.
- Outside diameter (D): 16 mm on the 10x16 sintered bronze bushing, against 12 mm on the 9x12 and 14 mm on the 10x14.
- Chamfer, maximum (C): up to 0.4 mm on the 10x16 sintered bronze bushing, against up to 0.3 mm on the 9x12 and up to 0.3 mm on the 10x14.
- Chamfer angle (C_angle): 45° on the 10x16 sintered bronze bushing, the same on the 9x12 and the 10x14.
Other sizes
Conventions
- Simplified only: a bush has no thread, so there is one detail level. STEP AP214, millimetres, Z the axis, one end face at Z = 0 and the other at Z = L.
- Nominal sizes: the sources give tolerance classes, not limits (before fitting G7/G8 bore, s7/s8 outside, js13 length; H7 or H8 bore after press-fitting), so the model is the nominal part before fitting, concentric.
- A chamfer C, at C_angle from the axis, on the bore and outside edges at both ends: Table 2's maximum for the wall (D - d)/2, modeled at the limit, within the owner's quarter-wall cap.
Documents
Sources
bowman-iso2795-plain, iso2795-2020-sample, iso2795-2020-sample-figures, selfoil-iso2795-plain. Full citations: the method page and this size's datasheet.
Found an error? Use the feedback section on this page.
Comments
Sign in to leave a comment.
Loading comments...