10x14 Sintered Bronze Bushing, ISO 2795
Pressed into a 14 mm housing bore, the 10x14 sintered bronze bushing (ISO 2795) carries a 10 mm shaft on its oil-filled wall. It comes in 3 lengths from 8 to 16 mm, each as simplified STEP.

How these parts are made, and what the levels mean: read the method
- Also known as: 10x14 oilite bushing, 10x14 sleeve bearing, 10x14 plain bearing, 10x14 self-lubricating bush, 10x14 x 8 to 10x14 x 16
- Model id:
iso2795-c-10x14
- Standard: ISO 2795:2020 · size 10x14
Lengths
| Length (mm) | Part key | Simplified |
|---|
| 8 | iso2795-c-10x14x8 | STEP |
| 10 | iso2795-c-10x14x10 | STEP |
| 16 | iso2795-c-10x14x16 | STEP |
Dimensions

| Symbol | Name | min | nom | max | Modeled | Rule | Level |
|---|
| d | Inside diameter | | 10 | | 10 | nominal | L2 |
| D | Outside diameter | | 14 | | 14 | nominal | L2 |
| C | Chamfer, maximum | | | 0.3 | 0.3 | single limit (max), modeled at the limit | L2 |
| C_angle | Chamfer angle | | 45 | | 45 | nominal | L1 |
Drawing

As a PDF: CC-ISO2795-SZ-10x14.pdf.
The 10x14 sintered bronze bushing beside the 10x16 and the 12x18
The 10x14 is number 18 of the 20 ISO 2795 sintered bronze bushings published here, listed from 2x5 to 12x16.
- Inside diameter (d): 10 mm on the 10x14 sintered bronze bushing, against 10 mm on the 10x16 and 12 mm on the 12x18.
- Outside diameter (D): 14 mm on the 10x14 sintered bronze bushing, against 16 mm on the 10x16 and 18 mm on the 12x18.
- Chamfer, maximum (C): up to 0.3 mm on the 10x14 sintered bronze bushing, against up to 0.4 mm on the 10x16 and up to 0.4 mm on the 12x18.
- Chamfer angle (C_angle): 45° on the 10x14 sintered bronze bushing, the same on the 10x16 and the 12x18.
Other sizes
Conventions
- Simplified only: a bush has no thread, so there is one detail level. STEP AP214, millimetres, Z the axis, one end face at Z = 0 and the other at Z = L.
- Nominal sizes: the sources give tolerance classes, not limits (before fitting G7/G8 bore, s7/s8 outside, js13 length; H7 or H8 bore after press-fitting), so the model is the nominal part before fitting, concentric.
- A chamfer C, at C_angle from the axis, on the bore and outside edges at both ends: Table 2's maximum for the wall (D - d)/2, modeled at the limit, within the owner's quarter-wall cap.
Documents
Sources
bowman-iso2795-plain, iso2795-2020-sample, iso2795-2020-sample-figures, selfoil-iso2795-plain. Full citations: the method page and this size's datasheet.
Found an error? Use the feedback section on this page.
Comments
Sign in to leave a comment.
Loading comments...