12x16 Sintered Bronze Bushing, ISO 2795
For a 12 mm shaft in a 16 mm housing bore, this 12x16 sintered bronze bushing (ISO 2795) presses in and runs on the oil in its sintered wall. Modeled as 3 lengths from 8 to 20 mm, each as simplified STEP.

How these parts are made, and what the levels mean: read the method
- Also known as: 12x16 oilite bushing, 12x16 sleeve bearing, 12x16 plain bearing, 12x16 self-lubricating bush, 12x16 x 8 to 12x16 x 20
- Model id:
iso2795-c-12x16
- Standard: ISO 2795:2020 · size 12x16
Lengths
| Length (mm) | Part key | Simplified |
|---|
| 8 | iso2795-c-12x16x8 | STEP |
| 12 | iso2795-c-12x16x12 | STEP |
| 20 | iso2795-c-12x16x20 | STEP |
Dimensions

| Symbol | Name | min | nom | max | Modeled | Rule | Level |
|---|
| d | Inside diameter | | 12 | | 12 | nominal | L2 |
| D | Outside diameter | | 16 | | 16 | nominal | L2 |
| C | Chamfer, maximum | | | 0.3 | 0.3 | single limit (max), modeled at the limit | L2 |
| C_angle | Chamfer angle | | 45 | | 45 | nominal | L1 |
Drawing

As a PDF: CC-ISO2795-SZ-12x16.pdf.
The 12x16 sintered bronze bushing beside the 12x18
The 12x16 is the last of the 20 ISO 2795 sintered bronze bushings published here, listed from 2x5 to 12x16.
- Inside diameter (d): 12 mm on the 12x16 sintered bronze bushing, the same on the 12x18.
- Outside diameter (D): 16 mm on the 12x16 sintered bronze bushing, against 18 mm on the 12x18.
- Chamfer, maximum (C): up to 0.3 mm on the 12x16 sintered bronze bushing, against up to 0.4 mm on the 12x18.
- Chamfer angle (C_angle): 45° on the 12x16 sintered bronze bushing, the same on the 12x18.
Other sizes
Conventions
- Simplified only: a bush has no thread, so there is one detail level. STEP AP214, millimetres, Z the axis, one end face at Z = 0 and the other at Z = L.
- Nominal sizes: the sources give tolerance classes, not limits (before fitting G7/G8 bore, s7/s8 outside, js13 length; H7 or H8 bore after press-fitting), so the model is the nominal part before fitting, concentric.
- A chamfer C, at C_angle from the axis, on the bore and outside edges at both ends: Table 2's maximum for the wall (D - d)/2, modeled at the limit, within the owner's quarter-wall cap.
Documents
Sources
bowman-iso2795-plain, iso2795-2020-sample, iso2795-2020-sample-figures, selfoil-iso2795-plain. Full citations: the method page and this size's datasheet.
Found an error? Use the feedback section on this page.
Comments
Sign in to leave a comment.
Loading comments...