Extrusion joining plate, inline, Land T, vs-t-5
Size drawing - vs-t-5 values on the views - enlarged 2:1
Source levels Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both. < / = = the source gives only that limit, modeled at it. ref = reference. L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate. Hole diameter LO = one source only: printed amber and marked *. c =a source value was corrected; the datasheet says how. House convention = a detail no source dimensions,
holes: n = 5*, d = 5.10* Leg width
Thickness
Number of holes
drawn to a stated house rule. Hole spacing This size's values: LO 15. Notes No published standard: each plate is its reference maker's design (ADR 0034). Blank: that plate's drawing doesn't use the symbol. Hole to outer edge Mark: sheet DO2.
Hole to end
T plate height
Stem left edge ordinate
Stem right edge ordinate
Second hole ordinate
Third hole ordinate
Upper hole ordinate
Top hole ordinate
TITLE
'? CommunityCAD Size drawing, vs-t-5
STANDARDS FOLLOWED FAMILY / DETAIL No published standard (makers' drawings) Extrusion joining plate - vs-t-5
SHEET REV SCALE PROJECTION UNITS
CC-JOINPLATE-SZ-vs-t-5 A 21 co Dimensions in mm SPEC VERSION LICENSE PAGE c964ffabe3a887708eb3e6e0cal8e3b2147b3b9c CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.