M8 Split Lock Washer, DIN 127
Made for M8 screws, this split lock washer (DIN 127) has an 8.1 to 8.5 mm hole and is up to 14.8 mm across, 4 to 4.7 mm thick. Download it as simplified STEP files.

How these parts are made, and what the levels mean: read the method
- Also known as: M8 spring washer, M8 helical spring lock washer, M8 lock washer
- Model id:
din127-b-m8
- Standard: DIN 127:1987 · size M8
Files
| Part key | Simplified |
|---|
din127-b-m8 | STEP |
Dimensions

| Symbol | Name | min | nom | max | Modeled | Rule | Level |
|---|
| d1 | Inside diameter | 8.1 | | 8.5 | 8.3 | midpoint of min–max | L1 |
| d2 | Outside diameter | | | 14.8 | 14.8 | single limit (max), modeled at the limit | L1 |
| b | Section width | 2.85 | 3 | 3.15 | 3 | nominal | L1 |
| s | Section thickness | 1.9 | 2 | 2.1 | 2 | nominal | L1 |
| r | Section corner radius | | 0.5 | | 0.5 | nominal | L1 |
| h | Free height | 4 | | 4.7 | 4.35 | midpoint of min–max | L1 |
Drawing

As a PDF: CC-DIN127-SZ-M8.pdf.
Goes with the M8 split lock washer
The M8 split lock washer beside the M6
The M8 is the largest of the 7 DIN 127 split lock washers published here, from M2 to M8.
- Inside diameter (d1): 8.1 to 8.5 mm on the M8 split lock washer, against 6.1 to 6.5 mm on the M6.
- Outside diameter (d2): up to 14.8 mm on the M8 split lock washer, against up to 11.8 mm on the M6.
- Section width (b): 3 mm on the M8 split lock washer, against 2.5 mm on the M6.
- Section thickness (s): 2 mm on the M8 split lock washer, against 1.6 mm on the M6.
- Section corner radius (r): 0.5 mm on the M8 split lock washer, against 0.3 mm on the M6.
- Free height (h): 4 to 4.7 mm on the M8 split lock washer, against 3.2 to 3.8 mm on the M6.
Other sizes
Conventions
- Simplified only: a washer has no thread, so there is one detail level. STEP AP214, millimetres, Z up, lowest point on Z = 0, the split on +X.
- Bore d1 at its min/max midpoint; section width b and thickness s at their nominals; the outside is d1 + 2b, within d2 max.
- Free height h at its form B midpoint: one right-hand turn of a helix at a constant lead, so the envelope runs Z = 0 to h.
Documents
Sources
fasten-it-din127, fasteners-eu-din127, fasteners-eu-din127-a-section, globalfastener-din127, globalfastener-din127-a-section. Full citations: the method page and this size's datasheet.
Found an error? Use the feedback section on this page.
Comments
Sign in to leave a comment.
Loading comments...