DIN 6799 retaining washer for shafts (E-clip), 7 mm groove
Size drawing - 7 mm groove values on the views - enlarged 5:1
Sym. Dimensi
Clip thickness
Outer diameter, installed (max)
Groove diameter (the size)
Mouth width, loose (not modeled)
Shaft diameter range
Groove width
@d3 <= 14.30
Groove edge margin (min)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L17 - LO 2.
Notes
Sizes are the groove diameter d2; the clip is drawn and modeled installed in it. d3 max is modeled at its limit; a is the loose clip's mouth width, not modeled. The outline (lugs, pockets, jaws, arm ends) is house construction, sheet DO2. di, m, n: the shaft and its groove, tabulated for your design, not modeled.
View from above, installed
TITLE
'? CommunityCAD Size drawing, 7 mm groove
STANDARDS FOLLOWED FAMILY / DETAIL DIN 6799:2017-06 Retaining washer for shafts (E-clip) - 7 mm groove
SHEET REV SCALE PROJECTION UNITS
CC-DIN6799-SZ-7 A 5:1 € Dimensions in mm SPEC VERSION LICENSE PAGE c964ffabe3a887708eb3e6e0cal8e3b2147b3b9c CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.