ISO 1234 split pin, 1.2
Size drawing - 1.2 values on the views - | = 8 shown: enlarged 10:1
|= 8 shown lengths 8-25
bearing point
d=0.95 0.9-1.0
ends square cut (end form not specified)
Sym. | Nominal size le @) 1.2
0.95 0.9-1.0
Pin diameter, across both legs
1.875 1.25-2.50
Extended prong (long leg past short)
3 ref
Eye length, bearing point to eye end
Eye width, outside
Eye path radius ((c - d)/2)
Eye path centre above bearing (b - c/2)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 4.
Notes
Nominal size = the split-pin hole's diameter; d is the pin's own, smaller.
b s in the standard: a reference value (ref), modeled as given.
b runs from the eye's far end to where it bears on the hole; | from there.
Ends square cut: end form not specified by the standard.
TITLE
'? CommunityCAD Size drawing, 1.2
STANDARDS FOLLOWED
ISO 1234:1997
FAMILY / DETAIL
Split pin - 1.2
SHEET
CC-1801234-SZ-1.2 A 10:1
REV SCALE PROJECTION
UNITS
Dimensions in mm
SPEC VERSION
LICENSE
4aeSbf9e66e8308247edFcSddd7a850ae355fc17 CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.