Extrusion joining plate, inline, L and T, vs-I-5
Size drawing - vs-I-5 values on the views - enlarged 2:1
Leg width
Thickness
Hole diameter Number of holes Hole spacing
Hole to outer edge Second hole ordinate
03 Third hole ordinate
p = 20* oo
q2 Upper hole ordinate
holes: n = 5*, d = 5.10* q3 Top hole ordinate Source levels Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: LO 11.
Notes
No published standard: each plate is its reference maker's design (ADR 0034). Blank: that plate's drawing doesn't use the symbol. Mark: sheet D02.
TITLE
'? CommunityCAD Size drawing, vs-I-5
STANDARDS FOLLOWED FAMILY / DETAIL
No published standard (makers' drawings) Extrusion joining plate - vs-I-5
SHEET REV SCALE PROJECTION UNITS CC-JOINPLATE-SZ-vs-1-5 A 2:1 € Dimensions in mm SPEC VERSION LICENSE PAGE c964Ffabe3a887708eb3e6e0cal8e3b2147b3b9c CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.