* CC-TNUTH-DS-s10-M8 rev A '?) CommunityCAD Size datasheet - s10-M8
slot 10 M8 hammer -head T -slot nut
Size datasheet: this size's values with their levels, conventions and sources.
For slot 10 aluminium extrusions Part key slot-nuts-hammer-s10-m8 MI Files 2 STEP AP214 (simplified, threaded) s10-M8, top, 2:1 s10-MB, end, 2:1 (hidden lines dashed)
Sym. Dimension Value Level
Ww Body width across the slot 17 La - 2
L Body length along the slot 10* lo -1
b Neck width 9.8 L1- 2
h Overall height 9.0 L1- 2
k Body height 6.0 L1- 2
n Neck height 3.0 L1- 2
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
No published standard (makers' drawings) Page 1/2 Hammer-head T-slot nut - s10-M8 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 393cOd5eb300576c4b007F88cdde7Ffd1c026d7F4
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
* CC-TNUTH-DS-s10-M8 rev A '?) CommunityCAD Size datasheet - s10-M8
Conventions
e Rounded corners and flanks: Two diagonal corners rounded to the width's arc, so the nut turns within its length, and the body's lower edges chamfered 45 degrees by k/2. Both illustrative, not any maker's dimensions.
+ Values: No published standard: each value the reference maker's drawing (Misumi). A second maker's value counts as agreeing where the slot leaves room for the difference, computed from the profile's data, and a size where a value stands on one maker is labelled single source.
e Fit: A nut is checked against its slot system's one-cell profile, never fitted to it: neck no wider than the opening, width no wider than the undercut, body no taller than the cavity.
« Finish: Brushed stainless: render and metadata only. No markings, no serrations, other edges sharp. Bottom face at Z = 0, the neck toward +Z.
Sources
Source Publisher Retrieved sha256
misumi-hammer-nuts MISUMI 2026-10-30 ef5782b7977a (kept outside the repo) motedis-hammer-nuts Motedis 2026-10-30 e86e703313ed (kept outside the repo) rule-motedis-hammer-nut-heights CommunityCAD 2026-10-31 87e163a9a166 rule-misumi-hammer-nut-neck CommunityCAD 2026-11-03 d573#37888b3
The whole series (verification map, corrections, drawings): CC-TNUTH-DS.
No published standard (makers' drawings) Page 2/2 Hammer-head T-slot nut - s10-M8 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 393cOd5eb300576c4b007F88cdde7Ffd1c026d7F4
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.