* CC-TNUTS-DS-s10-M5 rev A '?) CommunityCAD Size datasheet - s10-M5
slot 10 M5 slide -in T -slot nut
Size datasheet: this size's values with their levels, conventions and sources.
For slot 10 aluminium extrusions Part key slot-nuts-slide-in-s10-m5 q J Files 2 STEP AP214 (simplified, threaded)
s10-M5, top, 1:1 s10-M5, end, 2:1 (hidden lines dashed) Sym. Dimension Value Level Ww Body width across the slot 17 La - 2 1 Body length along the slot 17x lo: 1 b Neck width 9.8 Li + 2 h Overall height 9 Li + 2 k Body height 6 Li + 2 n Neck height 3 Li + 2
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
No published standard (makers' drawings) Page 1/2 Slide-in T-slot nut - s10-M5 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 393cOd5eb300576c4b007F88cdde7Ffd1c026d7F4
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
CC-TNUTS-DS-s10-M5 rev A Size datasheet -s10-M5
'?) CommunityCAD
Conventions
+ Lead-ins and flanks: 45 degree chamfers of I/10 on the four corners at the nut's two ends, and the body's lower edges chamfered 45 degrees by k/2. Both illustrative, not any maker's dimensions.
+ Values: No published standard: each value the reference maker's drawing (Misumi). A second maker's value counts as agreeing where the slot leaves room for the difference, computed from the profile's data, and a size where a value stands on one maker is labelled single source.
e Fit: A nut is checked against its slot system's one-cell profile, never fitted to it: neck no wider than the opening, width no wider than the undercut, body no taller than the cavity.
« Finish: Brushed stainless: render and metadata only. No markings, no serrations, other edges sharp. Bottom face at Z = 0, the neck toward +Z.
Sources
Source Publisher Retrieved sha256
misumi-slide-in-nuts MISUMI 2026-11-02 #9cc15la2bdf (kept outside the repo) motedis-slide-in-nuts Motedis 2026-11-03 ad7e2de57163 (kept outside the repo) rule-motedis-slide-in-nut-heights CommunityCAD 2026-11-03 ef27c54b7F3c pule-misumi-slide-in-nut-neck CommunityCAD 2026-11-03 9a8798514ca2
The whole series (verification map, corrections, drawings): CC-TNUTS-DS.
No published standard (makers' drawings) Page 2/2 Slide-in T-slot nut - s10-M5 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 393cOd5eb300576c4b007F88cdde7Ffd1c026d7F4
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.