CC-ENDCAP-DS-s10-45x90 rev A Size datasheet - s10-45x90
'?) CommunityCAD
45x90 slot 10 extrusion end cap
Size datasheet: this size's values with their levels, conventions and sources.
te
co
For 45x90 slot 10 aluminium extrusion ends
U KS Part key extrusion-end-caps-s10- WH 45x90
iL Files 1 STEP AP214 (simplified) co Uu s10-45x90, outer face, 0.5:1 s10-45x90, edge, 0.75:1 (hidden lines dashed)
Sym. Dimension Value Level a Cap width 45 L1- 2 h Cap height 90 Lia - 2 t Seat thickness 3x lo- 1 P Corner radius 3x lo-4
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
No published standard (makers' drawings) Page 1/2 Extrusion end cap - s10- 45x90 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 1195d6e9533baé6db9eb2f578cae540746ef8dbb2
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
* CC-ENDCAP-DS-s10-45x90 rev A '?) CommunityCAD Size datasheet - s10-45x90
Conventions
« Plugs: One push-in cross plug per profile cell, centred on the cell's core bore: two crossed ribs d/4 thick, their ends on the bore's circle, d long below the back face, the cell pitch p and core bore d from the profile's spec data. The cross plugs, the face's edge round and the recessed mark are illustrative, not any maker's design (ADR 0100 rows 3, 5, 6).
« Face edge and mark: The outer face's perimeter rounded t/4; every other edge sharp. The CommunityCAD mark recessed 0.3 mm into the outer face at its centre, side 0.4 x the smaller of a and h.
« Values: No published standard: the outline a x h from two makers (it equals the profile's); the seat thickness t and corner radius r the reference maker's; where its drawing gives no r, the profile's outside corner radius.
e Finish: Matte black plastic (polyamide, as every maker sells it): render and metadata only. Back face (seated on the profile's end) at Z = 0.
Sources
Source Publisher Retrieved sha256
misumi-end-caps MISUMI 2026-10-29 8039d0f1cb99 (kept outside the repo) motedis-end-caps Motedis 2026-10-29 fee1a43d0584 (kept outside the repo)
The whole series (verification map, corrections, drawings): CC- ENDCAP-DS.
No published standard (makers' drawings) Page 2/2 Extrusion end cap - s10- 45x90 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 1195d6e9533baé6db9eb2f578cae540746ef8dbb2
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.