v0.1 | MAY 2020
PAMS: Camera Quick Clamp ¢ Makers Making
ASSEMBLY GUIDE ANE Squire Program
epevss |
---
v0.1 | MAY 2020
PAMS: Camera Quick Clamp Cy Makers Making ASSEMBLY GUIDE AN Squire Program PARTS
5 3
Description
Main Body, 3D printed
Secondary Body, 3D printed
Lever handle, 3D printed
Latch Arm, 3D printed
Bolt cover, 3D printed
Long Pin, 3D printed
Short Pin, 3D printed
Bolt, 1/4” - 20 UNC x 0.5 in. length
ON DD UB Wine PoP) NM PIP PBI R
epevss |
---
V0.1 | MAY 2020
PAMS: Camera Quick Clamp Cy Makers Making
TOOLS AND SUPPLIES
Description
Superglue
Needle nose pliers (Optional)
@)=s
© 2020 by Neil Squire. “Assembly Guide” licensed under the CC BY SA 4.0 License: http://creativecommons.org/licenses/by-sa/4.0 Design files available at https://www.makersmakingchange.com/project/pams-camera-quick-clamp/ PAGE 3 OF 4
---
V0.1 | MAY 2020
PAMS: Camera Quick Clamp Makers Maing ASSEMBLY GUIDE ANei Squire Program
02 Remove built-in support material from secondary e body.
03 Remove built-in support material from lever e handle.
Assemble main body, secondary body, lever 05 - handle and latch arm as shown with long and 06 e 'nsert bolt into main body. short pins.
08 Use a drop of superglue on each of the pins and the e
07 ° Slide bolt cover into slot in main body. bolt cover slot.
@)=s
© 2020 by Neil Squire. “Assembly Guide” licensed under the CC BY SA 4.0 License: http://creativecommons.org/licenses/by-sa/4.0 Design files available at https://www.makersmakingchange.com/project/pams-camera-quick-clamp/ PAGE 4 OF 4