Brushed DC can motor, can class, 130
Size drawing - 130 values on the views - enlarged 3:1
Sym. Dimensi
Can diameter
Width across the flats
Body length
Overall length, not modeled 38.0 ref
Shaft length from the mounting face 7.4
Shaft diameter Bole
Front boss diameter
Front boss height
Rear boss diameter
hr Rear boss height
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 10.
Notes
No published standard: each maker's drawing is its own lineage (ADR 0034). Where makers differ, the largest stated (ADR 0134 row 4).
End cap, bell, vents, terminals and mark illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, 130
STANDARDS FOLLOWED FAMILY / DETAIL Makers' drawings (Mabuchi, Johnson Electric, AndyMark); no published standard Brushed DC can motor - 130
SHEET REV SCALE PROJECTION UNITS
CC-DCMOTOR-SZ-130 A 3:1 € Dimensions in mm SPEC VERSION LICENSE PAGE 06d85a526417d7ca3bac879661c871d1530757a CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.