. CC-DCMOTOR-DS-130 revA '?) CommunityCAD Size datasheet - 130
Mabuchi FA-130RA, 130 DC motor
Size datasheet: this size's values with their levels, conventions and sources.
For 130 motor mounts, clamps and pinions
Part key dc-motors-130
Files 1 STEP AP214 (simplified)
130, mounting face, 1:1 130, side, 0.5:1 (hidden lines dashed) Sym. Dimension Value D Can diameter 20.1 W Width across the flats 15.1 L Body length 25.0 Lt Overall length, not modeled 38.0 ref E Shaft length from the mounting face 9.4 d Shaft diameter 2.0 B Front boss diameter 6.15 h Front boss height 1.7 Br Rear boss diameter 10.0 hr Rear boss height Qo
Modeled value: nominal, else the midpoint of min-max. < / 2: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
Makers' drawings (Mabuchi, Johnson Electric, AndyMark); no published standard Page 1/2 Brushed DC can motor - 130 - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec 06d85a526417d7ca3bac879661c871d1530757a
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
* CC-DCMOTOR-DS-130 revA '?) CommunityCAD Size datasheet - 130
Conventions
» Where makers differ: The largest stated can, body, shaft length and bosses, and the highest stated maximum over the end bell, so a mount made to the model clears every maker's motor; each maker's value is on the size's page.
« Can and end cap: Nickel- plated can, its front edge rounded 0.03 D; the rear 0.18 L is the end cap: black nylon set in from the wall on the 130 and 280, a steel end bell with a seam groove, brush-holder bulges (to Dx where stated) and four vent windows over a nylon brush plate on the 540, 550 and 775. Illustrative, checked for fit only.
« Holes, face and shaft: Tapped holes as plain bores at the thread's nominal diameter, 1.5 x that deep (the 280's plain holes the same at dh); two shallow vent slots in the large cans' face; chamfers on the shaft's end and the front boss. Illustrative.
e Terminals and mark: Two tinned solder tabs at the rear on +X, each with a hole; a red polarity dot beside the + tab; the CommunityCAD mark debossed in the rear face. Illustrative.
« Modeled from Mabuchi's FA-130RA drawing alone, a maker drawing of its named part (ADR 0089).
Sources Source Publisher Retrieved sha256 mabuchi-fa130ra Mabuchi Motor (compiled and hosted by mlab.cz) 2026-11-05 cc58c67b9541
The whole series (verification map, corrections, drawings): CC- DCMOTOR-DS.
Makers' drawings (Mabuchi, Johnson Electric, AndyMark); no published standard Page 2/2 Brushed DC can motor - 130 - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec 06d85a526417d7ca3bac879661c871d1530757a
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.