DIN 6923 hexagon nut with flange, M8
Size drawing - M8 values on the views - enlarged 5:1
e 2 14.38
da = 8.375
s = 12.865 12.73-13
Sym. Dimensi
Thread pitch
Nut height
Flange thickness
Flange diameter
Top chamfer ang!
Tap drill (method
M8
1.25
12.865 12.73-13
Width across flats
2 14.38
Width across corners
7.8 7.6-8
24.5
Wrenching height
> at the rim B tod
Bearing face diameter
Countersink diameter
Fillet, hexagon to flange
ISO 4032 dw (top chamfer circle)
le (ISO 4032), deg
Countersink angle (ISO 4032), deg
Basic minor diameter (crests)
D-P)
'? CommunityCAD
TITLE
Size drawing, M8
Source levels
Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both.
s/ 2 = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L2 11- L116.
Notes
s: the nominal is the wrench size (= s max); modeled at the middle of its band (ADR 0014).
eis not modeled on its own: the regular hexagon gives e = 2s/v3 from the modeled s, = e min.
dw' (ISO 4032 dw min at the same s) sets the top chamfer's face circle, (dw' +s)/2.
The flange cone meets the corners at (c +m -m' min) / 2; m' min is checked over each flat.
ris modeled at r max, except at M8: the largest r that keeps m' min at mid-flat (#662).
dw min sets the bearing edge round, (dc - dw min) / 4. Plain bearing face, no serrations.
STANDARDS FOLLOWED DIN 6923:1983 - ISO 4032:2012 (top chamfer, 8) - ISO 68-1/ ISO 261 (thread)
FAMILY / DETAIL
Hexagon flange nut - M8
SHEET REV
CC-DIN6923-SZ-M8 A
SCALE PROJECTION
5:1
UNITS
Dimensions in mm
SPEC VERSION cfd05b053c736a4F15ba3030aa41Febd40cdc205
LICENSE CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
