M6 Square Nut, DIN 557 size drawing (PDF)

Datasheet — M6 Square Nut, DIN 557 by Milo

Open the PDF
M6 Square Nut, DIN 557Get the CAD modelM6 Square Nut, DIN 557CC-DIN557-SZ-M6.pdf

Text of this datasheet

DIN 557 square nut (product grade C), M6

Size drawing - M6 values on the views - enlarged 5:1

Sym. Dimensi

Thread pitch

9.82 9.64-10

1 Width across flats e = 13.315

12.53-14.1

13.315 12.53-14.1

Width across corners

4.76 4.52-5

Nut height

3.2

Height at the corners

8.7 Bearing face diameter

B = 22.5°*

15°-30° Chamfer angle, deg

Basic minor diameter (crests)

tap Tap drill (method D - P)

e = 13.315 Source levels 12.53-14.1 Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both. < / = = the source gives only that limit, modeled at it. ref = reference. L2 = the standard itself (or its complete free preview, or the maker's drawing).

View from above (the plain face)

L1 = two or more independent sources agree: the release gate.

LO = one source only: printed amber and marked *.

c = a source value was corrected; the datasheet says how.

House convention = a detail no source dimensions, drawn to a stated house rule.

This size's values: L2 1- L112 - LO 1.

Notes

s: the nominal is the wrench size (= s max); modeled at the middle of its band (ADR 0014). e is not modeled on its own: the sharp square gives e = s-v2 from the modeled s, checked. dw min sets the bearing-face chamfer's face circle, (dw min + s) / 2.

mw min is checked at the corners (the square's height left above the chamfer).

B is the owner's entry from a maker drawing (one source, not required).

TITLE

'? CommunityCAD Size drawing, M6

STANDARDS FOLLOWED FAMILY / DETAIL

DIN 557:1994-01 - ISO 68-1/ ISO 261 (thread) Square nut - M6

SHEET REV SCALE PROJECTION UNITS CC-DIN557-SZ-M6 A 5:11 € Dimensions in mm

SPEC VERSION LICENSE PAGE cfd05b053c736a4F15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.