DIN 315 wing nut, rounded wings, M5
Size drawing - M5 values on the views - enlarged 2:1
Sym. Dimensi
Thread pitch
Wing span
Overall height
Boss height
Boss foot diameter
d3 Boss top diameter
g1 Wing thickness at the top View fro}
g2 Wing thickness at the root
ri Wing lobe radius
rs Wing root radius (front)
ra Wing root radius (plan)
D1 Basic minor diameter (crests)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 1- L117.
Notes
Wing outline: lobe r1 touching e/2 and h, flanks tangent from d2/2 and d3/2 (house, DO2). Wing faces: planes, g2 at the bearing face to g1 at h. r4: plan view, at m (DO2). Wing edges (r2): the standard says 'rounded', no value at M4-MB8: sharp, pending. No countersink. D1: threaded level only (ISO 68-1 basic profile).
TITLE
'? CommunityCAD Size drawing, M5
STANDARDS FOLLOWED FAMILY / DETAIL
DIN 315:1998 - ISO 68-1 / ISO 261 (thread) Wing nut - M5
SHEET REV SCALE PROJECTION UNITS CC-DIN315-SZ-M5 A 2:1 € Dimensions in mm SPEC VERSION LICENSE PAGE acdf428c50c2166d020400a0cbdcc023c2d1118e CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.