ISO 10511 nylon insert lock nut (thin, non-metallic insert), M4
Size drawing - M4 values on the views - enlarged 5:1
Sym. Dimensi
Thread pitch
6.89 6.78-7.00
Width across flats
2 7.66 Width across corners
Hexagon height Loos
h = 4.76 Nut height (to the collar top) 4.76 4,52-5.00 4.52-5.00
m2 1.95 2 1.56
Wrenching height
da = 4.30 2 5.90 4.00-4.60 Bearing face diameter
4.30 4.00-4.60
Countersink diameter
22.5 15-30
Corner chamfer angle, deg
105
Countersink angle, deg 90-120
Basic minor diameter (crests) arr
s = 6.89
6.78-7.00 3.3
tap Tap drill (method D - P)
Source levels Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both. < / = = the source gives only that limit, modeled at it. ref = reference. L2 = the standard itself (or its complete free preview, or the maker's drawing). e= 7.66 L1 = two or more independent sources agree: the release gate. LO = one source only: printed amber and marked *. c = a source value was corrected; the datasheet says how. House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 11-L16. Notes s: modeled at the middle of its s min-max band (ADR 0014). m is modeled at m min. e is not modeled on its own: the regular hexagon gives e = 2s/v3 from the modeled s, = e min. dw min sets the corner chamfer's face circle, (dw min + s) / 2; mw min is checked at mid-flat. No washer face (ISO 10511 has none, so no c). Countersink on the bearing face only (ADR 0047).
View from above
TITLE
'? CommunityCAD Size drawing, M4
STANDARDS FOLLOWED FAMILY / DETAIL
ISO 10511:2012 (withdrawn) - ISO 68-1 / ISO 261 (thread) Lock nut - M4
SHEET REV SCALE PROJECTION UNITS CC-1S8010511-SZ-M4 A 5:11 € Dimensions in mm
SPEC VERSION LICENSE PAGE cfd05b053c736a4F15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
