M4 Hex Bolt, ISO 4014 size drawing (PDF)

Datasheet — M4 Hex Bolt, ISO 4014 by Milo

Open the PDF
M4 Hex Bolt, ISO 4014Get the CAD modelM4 Hex Bolt, ISO 4014CC-ISO4014-SZ-M4.pdf

Text of this datasheet

ISO 4014 hexagon head bolt, M4

Size drawing - M4 values on the views - | = 25 shown - enlarged 2:1

Source levels Sym. Dimensi Main value = the modeled value (nominal, else the

middle of min-max). Thread pitch . Grey under a value = its min-max, where the source

gives both.

6.89 </ = = the source gives only that limit, modeled at 6.78-7.00 it. ref = reference. ° L2 = the standard itself (or its complete free B= 22.5° K=28 = 0.275 Width across corners 2 7.66 preview, or the maker's drawing). =. = WV. L1 = two or more independent sources agree: the 2.675-2.925 0.15-0.40 y

T : 2.8 release gate.

Head height LO = ly: printed b d ked * dw = 6.20c —— 9 675-2.995 = one source only: printed amber and marked *. r20.20 das 4.7 c = a source value was corrected; the datasheet

2 0.20, =4. 2 Ig < 11.0, Is = 7.5 Wrenching height 2 1.87 says how. House convention = a detail no source dimensions,

Width across flats

0.275 drawn to a stated house rule.

|= 25 shown Washer face height 9 15-0 40 This size's values: L2 15 - L16.

lengths 25-40 . Notes

2 6.20c s: modeled at the middle of its band; e and kw are

checks, not modeled.

Bearing face diameter

Head top chamfer, deg

= 50° (ISO 4753 CH)

! Underhead fillet radius 1 |

d1 = 3.2422

Transition diameter

3.91 3.82-4.00

Shank diameter View from above

Thread length a8 (ee

s=6.89

6.78-7.00 Transition length

Basic minor diameter (end face)

Tap drill (method d - P)

End chamfer angle, deg

TITLE

'? CommunityCAD Size drawing, M4

STANDARDS FOLLOWED FAMILY / DETAIL

ISO 4014:2022 - ISO 4753:2011 (ends) - ISO 68-1/ ISO 261 (thread) Hex head bolt - M4

SHEET REV SCALE PROJECTION UNITS CC-1S804014-SZ-M4 A 2:1 € Dimensions in mm SPEC VERSION LICENSE PAGE

cfd05b053c736a4F15ba3030aa41Febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.