* CC-HSINSERT-DS-M2x4 rev A '?) CommunityCAD Size datasheet - M2x4.
M2x4 heat-set insert
Size datasheet: this size's values with their levels, conventions and sources.
For M2 screws in 3D-printed and moulded plastic Part key heat-set-inserts-m2x4 Files 2 STEP AP214 (simplified, threaded) M2x4, top, 6:1 M2x4, side, 5:1 (hidden lines dashed) Sym. Dimension Value Level L Length 4.0* lo-1 di Knurl outside diameter 3.6% la - 1 d2 Pilot diameter 3.1* Lo- 1
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
No published standard (makers' tables) Page 1/2 Heat- set threaded insert - M2x4 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 1431dca0786db211c4968b488128bféd30bccS5db
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
CC-HSINSERT-DS-M2x4 rev A Size datasheet - M2x4
'?) CommunityCAD
Conventions
e Knurl and pilot: Two knurled bands of opposite hand, a groove, a lead and a pilot: their proportions are illustrative, not any maker's design, measured for fit only. Only L, d1 and d2 come from the makers' tables.
e Thread: Simplified: plain bands at d1 and a plain bore at the nominal diameter, so it mates with simplified screws. Threaded: the ISO 68-1 basic internal profile, right hand, the full length, with a 90 degree countersink to the nominal diameter at both ends.
« Values: No published standard: makers' tables. L and d1 count as agreeing only between ruthex and CNC Kitchen; RS PRO counts with ruthex. d2 may stand on ruthex alone, and on CNC Kitchen's three shortest inserts it is ruthex's from the next longer insert with the same thread and d1. Sizes on one maker's table are labelled single source.
« Finish: Polished lead-free brass: render and metadata only. No markings, other edges sharp. Top face, flush with the part's surface, at Z = 0, the pilot end at Z = -L.
e Recommended hole, per maker: ruthex 3.2 mm.
« Wall around the hole, per maker: ruthex 1.3 mm.
e Minimum hole depth, per maker: ruthex 5.0 mm.
e The hole depth is each maker's callout on its drawing added to that maker's L, read twice by Claude, and the two reads agree (ADR 0055).
Sources Source Publisher Retrieved 256 ruthex-inserts ruthex GmbH (as published by 3D Jake GmbH) 2026-10-30 ef2e07cebd47 The whole series (verification map, corrections, drawings): CC- HSINSERT- DS. No published standard (makers' tables) Page 2/2 Heat- set threaded insert - M2x4 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 1431dca0786db211c4968b488128bféd30bccS5db
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.