ISO 4017 hexagon head screw, M2
Size drawing - M2 values on the views - | = 20 shown - enlarged 5:1
Sym. Dimensi
Thread pitch
Width across flats SoH View from above 3.82-4.00
= 22.5° 2 4.32
15°-30° Width across corners
1.4 1.275-1.525
0.10-0.25 =U. Head height
> Wrenching height 2 0.89
r2 0.10, das 2.6 Washer face height Dotti
0.10-6.25
> Bearing face diameter 2 3.34¢
Head top chamfer, deg
| = 20 shown ; lengths 4-20 Underhead fillet radius
Transition diameter
0.80 6.40-1.20
Thread run-out under head
Basic minor diameter (end face) 1.567
= 50° (ISO 4753 CH) Tap drill (method d - P)
End chamfer angle, deg
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 15 - L16.
Notes
s: modeled at the middle of its band; e and kw are checks, not modeled.
TITLE
'? CommunityCAD Size drawing, M2
STANDARDS FOLLOWED FAMILY / DETAIL
ISO 4017:2022 - ISO 4753:2011 (ends) - ISO 68-1/ ISO 261 (thread) Hex head screw - M2
SHEET REV SCALE PROJECTION UNITS CC-1804017-SZ-M2 A 5:11 € Dimensions in mm
SPEC VERSION LICENSE PAGE €05¢8289049003c09e32d8bd4ae913179e09a28c CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.