5.25-inch bay device envelope, half height
Size drawing - half height values on the views - scale 1:2
xs1 = 47.40
ps = 79.25
tb = 5.00
Hb = 42.30
dl = 3.5 house, tt = 1.25 house
Wb = 148.00
yb2 = 139.70
xb1 = 47.40 pb = 79.25
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 22.
Notes
SFF-8551 Rev 3.3 and SFF-8523 Rev 1.4, Table 5-1; H, L maxima, modeled at them. Holes: M3, two full threads below the house lead-in (#1381 item 2 B): dl and tt.
Ls 202.80
cb = 31.34 ref
W = 146.05
145.80-146.30
Sym. Dimensio!
Body height, A1 (max)
Body width, AS
Length behind the bezel, A4 (max) Bezel height, A2
Bezel width, A3
Bezel thickness, A17
Bezel front extent, A16 (recorded, not reached) Bezel to the first side holes, A10
Side holes apart, ATI
Side holes above the bottom, A13. Upper side holes above the bottom, A14 Bezel to the first bottom holes, A9 Bottom holes apart, A8
Side to the bottom holes, A7
Bottom holes across, A6
Connector width, A2 (SFF-8523) Datum B width, A3
Side to datum B, A13
Datum B centre off the centreline, ATI Connector centre height, A7 Connector height, AS
Connector end to datum C, A&
Lead-in @, 90° (house: D + P)
Full thread from the face (house: lead-in + 2 P)
S$ 41.53
146.05 145 80-146 .30
€ 202.80
42.30
148.00
5.00
3.18
139.70
42.73 ref
33.39 ref
31.34 ref
25.00
10.00 9.62-10.38
4.00 ref
4.90
3.5
TITLE
'? CommunityCAD
Size drawing, half height
STANDARDS FOLLOWED SFF-8551 Rev 3.3 - SFF-8523 Rev 1.4 (SNIA)
FAMILY / DETAIL
5.25-inch bay device - half height
SHEET REV SCALE
CC-BAYS25-SZ-half-height A 1:2
PROJECTION UNITS
Dimensions in mm
SPEC VERSION LICENSE cfd05b053c736a4F15ba3030aa41febd40cdc205
CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
