Mean Well LRS enclosed power supply, LRS-350
Size drawing - LRS-350 values on the views - terminal end at the left, as Mean Well draws it - scale 1:3
Terminal end Far end
Sym. Dimensi LRS-350
Length 215
Width 115
Height 30 General tolerance, +
Bottom holes' thread, M
Bottom holes, count
Bottom holes, depth L
Bottom holes from the terminal end
L=215
Bottom holes apart, along
ns =4,ds=4,ts=5,fs=2 Bottom holes from the front face Bottom holes apart, across wsl = 2, hsl = 6.9 Side holes' thread, M
zsl = 12.8, esl = 6.5, esr = 6.5 Side holes, count
Side hole faces (2: both long sides) Side holes, depth L
Side holes from the terminal end Side hole columns apart
xf = 47.45
First column's lowest hole, height
Fan grille (illustrative)
Side slot width
Side slot height
Side slot bottom, height
Side slot from its hole, terminal side
Side slot from its hole, far side
Terminal pitch
Terminal opening
P Terminals, count
. |. Fan centre to the far end’s inside face Fan centre from the back face
xb = 32.5 pxb = 150
Tab holes span (recorded)
Tab width (recorded) nb = 4, db = 4, tb =3
Tab reach (recorded)
Lead-in @, 90° (house: D + P)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. '? CommunityCAD Size drawing LRS-350 '
This size's values: L2 31. Notes STANDARDS FOLLOWED FAMILY / DETAIL
No published standard: Mean Well's datasheet drawing of each model Mean Well LRS enclosed power supply - LRS-350
TITLE
CommunityCAD's model from Mean Well's published drawing; not a Mean Well file (ADR 0141). Tapped holes: thread to the drawing's L, then a 118° drill point; dl is a house lead-in. SHEET REV SCALE PROJECTION UNITS
(recorded): on the drawing, in the data, not modeled (tabs, notch and chains to it). CC-PSULRS-SZ-1Lrs-350 A 1:3 Dimensions in mm
xf is measured to the far end plate's inside face; it places the illustrative grille. SPEC VERSION LICENSE PAGE Side slots (wsl x hsl): either side of each column's lowest side hole. cfd05b053c736a4f15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1 Not drawn on the sheets (house style, sheet DO2): perforation, vents, screws, label, mark.
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
