Enclosed Switching Power Supply, Mean Well LRS-200 size drawing (PDF)

Datasheet — Enclosed Switching Power Supply, Mean Well LRS-200 by Milo

Open the PDF
Enclosed Switching Power Supply, Mean Well LRS-200Get the CAD modelEnclosed Switching Power Supply, Mean Well LRS-200CC-PSULRS-SZ-lrs-200.pdf

Text of this datasheet

Mean Well LRS enclosed power supply, LRS-200

Size drawing - LRS-200 values on the views - terminal end at the left, as Mean Well draws it - scale 1:2.5 Terminal end Far end

Width

Height General tolerance, + Bottom holes' thread, M Bottom holes, count Bottom holes, depth L

Bottom holes from the terminal end

Bottom holes apart, along L = 215

Bottom holes from the front face ns =4,ds=4,ts=5,fs=2 Bottom holes apart, across

Side holes' thread, M

wsl = 2, hsl = 6.9

Side holes, count zsl = 12.8, esl = 6.5, esr = 6.5 Side hole faces (2: both long sides) Side holes, depth L

Side holes from the terminal end

Side hole columns apart

First column's lowest hole, height

Side slot width Side slot height

Side slot bottom, height

Side slot from its hole, terminal side Side slot from its hole, far side Terminal pitch

Terminal opening

Terminals, count

Tab holes span (recorded) Tab width (recorded)

pxb = 150

Tab reach (recorded)

Lead-in @, 90° (house: D + P)

nb = 4, db = 4, tb = 3

Source levels

Main value = the modeled value (nominal, else the middle of min-max).

Grey under a value = its min-max, where the source gives both.

< / = = the source gives only that limit, modeled at it. ref = reference.

L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.

LO = one source only: printed amber and marked *.

c = a source value was corrected; the datasheet says how. '? CommunityCAD Size drawing LRS-200

House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L2 29. STANDARDS FOLLOWED FAMILY / DETAIL

Notes No published standard: Mean Well's datasheet drawing of each model Mean Well LRS enclosed power supply - LRS-200

TITLE

CommunityCAD's model from Mean Well's published drawing; not a Mean Well file (ADR 0141). SHEET REV SCALE PROJECTION UNITS

Tapped holes: thread to the drawing's L, then a 118° drill point; dl is a house lead-in. CC-PSULRS-SZ-1Lrs-200 A 1:2.5 Dimensions in mm (recorded): on the drawing, in the data, not modeled (tabs, notch and chains to it). SPEC VERSION LICENSE PAGE Side slots (wsl x hsl): either side of each column's lowest side hole. cfd05b053c736a4F15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1 Not drawn on the sheets (house style, sheet DO2): perforation, vents, screws, label, mark.

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.