Mean Well LRS enclosed power supply, LRS-150F
Size drawing - LRS-150F values on the views - terminal end at the left, as Mean Well draws it - scale 1:2
Sym. Dimensi LRS-150F
Terminal end Far end
Length 159 xgs = 6.5 eng
Width 97 pxs = 117
Height General tolerance, +
Bottom holes' thread, M
H = 30) pzs = 18 Bottom holes, count
Bottom holes, depth L Bottom holes from the terminal end
Bottom holes apart, along
L = 159 Bottom holes from the front face Side holes' thread, M
ns = 3,ds = 3,ts=5 Side holes, count
Side holes, depth L
Side holes from the terminal end Side hole columns apart
First column's lowest hole, height
Second column's lowest hole, height
Holes up a column, apart
Plain hole, bottom, &
Plain hole from the terminal end Notch centre from the front face Plain hole from the notch
Plain hole, front face, @
Front plain hole from the terminal end Front plain hole, height
Terminal pitch
Terminal opening
I. Terminals, count
xb = 24 pxb = 78 Plain hole to the notch, along (recorded)
Front plain hole to the notch (recorded) Notch width (recorded) nb = 2, db = 3, tb = 3.0
Notch width, side view (recorded)
Notch height (recorded)
Source levels Lead-in @, 90° (house: D + P) Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *. '? CommunityCAD Size drawing, LRS-150F c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. STANDARDS FOLLOWED ; FAMILY / DETAIL No published standard: Mean Well's datasheet drawing of each model Mean Well LRS enclosed power supply - LRS-150F
TITLE
This size's values: L2 33. Notes SHEET REV SCALE PROJECTION UNITS
CommunityCAD's model from Mean Well's published drawing; not a Mean Well file (ADR 0141). CC-PSULRS-SZ-1Lrs-150f A 1:2 Dimensions in mm Tapped holes: thread to the drawing's L, then a 118° drill point; dl is a house lead-in. SPEC VERSION LICENSE PAGE (recorded): on the drawing, in the data, not modeled (tabs, notch and chains to it). cfd05b053c736a4F15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1 Not drawn on the sheets (house style, sheet DO2): perforation, vents, screws, label, mark.
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
