Mean Well LRS enclosed power supply, LRS-100
Size drawing - LRS-100 values on the views - terminal end at the left, as Mean Well draws it - scale 1:2
Sym. Dimensi Terminal end Far end
Length
xgs = 6.5
Width
Height General tolerance, +
Bottom holes' thread, M
H = 30) pzs = 18 Bottom holes, count
Bottom holes, depth L Bottom holes from the terminal end
Bottom holes from the front face
L=129 Bottom holes apart, across Side holes' thread, M
ns = 3, ds = 3, ts=5 Side holes, count
Side holes, depth L
Side holes from the terminal end Side hole columns apart
First column's lowest hole, height
Second column's lowest hole, height
Holes up a column, apart
Plain hole, bottom, & Plain hole from the terminal end Notch centre from the front face
Plain hole from the notch
pyb = 33) yg = 85
Plain hole, front face, @ Front plain hole from the terminal end Front plain hole, height
Terminal pitch
Terminal opening
Terminals, count
Plain hole to the notch, along (recorded) Front plain hole to the notch (recorded) Notch width (recorded)
nb = 2, db = 3, tb = 3.0
Notch width, side view (recorded)
Notch height (recorded)
Source levels Lead-in @, 90° (house: D + P) Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *. '? CommunityCAD Size drawing, LRS-100 c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. STANDARDS FOLLOWED ; FAMILY / DETAIL No published standard: Mean Well's datasheet drawing of each model Mean Well LRS enclosed power supply - LRS-100
TITLE
This size's values: L2 33. Notes SHEET REV SCALE PROJECTION UNITS
CommunityCAD's model from Mean Well's published drawing; not a Mean Well file (ADR 0141). CC-PSULRS-SZ-1Lrs-100 A 1:2 Dimensions in mm Tapped holes: thread to the drawing's L, then a 118° drill point; dl is a house lead-in. SPEC VERSION LICENSE PAGE (recorded): on the drawing, in the data, not modeled (tabs, notch and chains to it). cfd05b053c736a4F15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1 Not drawn on the sheets (house style, sheet DO2): perforation, vents, screws, label, mark.
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
