IEC 60086 coin and button cell, CR2430
Size drawing - CR2430 values on the views - enlarged 2:1
d = 24.35 24.20-24.50
r_neg = 1.00* 0.70-1.30
d = 24.35 24.20-24.50
Sym. Dimension CR2430
24.35 24.20-24.50
Diameter
2.85
Overall height 2.70-3.00
d_cap Negative cap diameter
h_cap Negative cap height
* r_neg Negative edge radius (LO) ahd
@.70-1.30
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L1 2 - LO 2.
Notes
No IEC 60086 edition is read: the values are the makers' datasheets, reconciled (ADR 0034). r_neg: Energizer's reference radius, one lineage, so always LO; modeled by the owner's decision (#786 item 4). The cap step is modeled only where d_cap and h_cap reach L1; - = not given (sheet DO2).
TITLE
'? CommunityCAD Size drawing, CR2430
STANDARDS FOLLOWED IEC 60086 (no edition read: makers' datasheets) Coin and button cell - CR2430
FAMILY / DETAIL
SHEET
REV SCALE PROJECTION UNITS
CC-IEC60086-COIN-SZ-CR2430| A 21 & Dimensions in mm
SPEC VERSION
LICENSE PAGE
cfd05b053c736a4F15ba3030aa41Febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
