C14 Power Inlet, Countersunk Screw Mount, Qualtek 703W-00/08 size drawing (PDF)

Datasheet — C14 Power Inlet, Countersunk Screw Mount, Qualtek 703W-00/08 by Milo

Open the PDF
C14 Power Inlet, Countersunk Screw Mount, Qualtek 703W-00/08Get the CAD modelC14 Power Inlet, Countersunk Screw Mount, Qualtek 703W-00/08CC-IECINLET-SZ-qualtek-703w-00-08.pdf

Text of this datasheet

IEC 60320 power inlet, per maker part number, qualtek-703w-00-08

Size drawing - qualtek-703w-00-08 values on the views - scale 1:1

@dh = 3.4, dk = 6.0

wr = 24, hr = 16

Sym.

wt tf rl wa ha ra wr hr ef p

dh dk wb hb

Dimensi

Flange width

Flange thickness Flange lobe radius Front face width

Front face height

Front face corner radius Coupler opening width Coupler opening height Front height

Mounting hole pitch Mounting hole diameter Countersink diameter Body width

Body height

Source levels

Main value = the modeled value (nominal, else the middle of min-max).

Grey under a value = its min-max, where the source gives both.

< / = = the source gives only that limit, modeled at it. ref = reference.

L2 = the standard itself (or its complete free preview, or the maker's drawing).

L1 = two or more independent sources agree: the release gate.

LO = one source only: printed amber and marked *.

c =a source value was corrected; the datasheet says how.

House convention = a detail no source dimensions, drawn to a stated house rule.

This size's values: L2 29.

Notes

A dash: that maker's drawing doesn't state it.

Panel cutouts and thicknesses: the maker's reference, not modeled.

Coupler face, pins, latches, rocker and drawer

illustrative: sheet DO2. pb Body corner radius

Lb Body depth it Terminal block depth tt Terminal thickness

cw = 28.0 Cutout width, front mounting Cutout height, front mounting Panel cutout, front mounting (the maker's reference, not modeled) Cutout corner radius Cutout chamfer (top corners) Cutout hole pitch

Cutout hole diameter

Cutout width, rear mounting

It = 13.7 Cutout height, rear mounting

Rear cutout corner radius

Rear cutout hole pitch

Rear cutout hole diameter

TITLE

'? CommunityCAD Size drawing, qualtek-703w-00-08

STANDARDS FOLLOWED FAMILY / DETAIL No published standard: each maker's own drawing IEC 60320 power inlet - qualtek-703w-00-08

rw = 30.3 SHEET REV SCALE PROJECTION UNITS CC-IECINLET-SZ-qualtek-703w-00-08 | A 1:1 Dimensions in mm

Panel cutout, rear mounting (the maker's reference, not modeled) ‘SPEC VERSION LICENSE PAGE 304229b833a653b73db51178a38d40486ee7c36b CC-BY 4.0 IronPixel Labs LLC 1/1

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.