Extrusion joining plate, inline, Land T, b8-t-4
Size drawing - b8-t-4 values on the views - scale 1:1
Leg width c = 5* x 45° Thickness
Hole diameter Number of holes Hole to end
Hole to outer edge T plate height holes: n = 4*, d = 6.6* Stem width
Stem hole spacing
Stem hole to end
Corner chamfer
Source levels Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: LO 12.
Notes
No published standard: each plate is its reference maker's design (ADR 0034). Blank: that plate's drawing doesn't use the symbol. Mark: sheet D02.
TITLE
'? CommunityCAD Size drawing, b8-t-4
STANDARDS FOLLOWED FAMILY / DETAIL No published standard (makers' drawings) Extrusion joining plate - b8-t-4
SHEET REV SCALE PROJECTION UNITS
CC-JOINPLATE-SZ-b8-t-4 A 1:1 € Dimensions in mm SPEC VERSION LICENSE PAGE
c964ffabe3a887708eb3e6e0cal8e3b2147b3b9c CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.