Extrusion joining plate, inline, L and T, b8-1-4
Size drawing - b8-I-4 values on the views - enlarged 1.5:1
c= 5* x 45°
holes: n = 4* d = 6.6*
Leg width
Thickness
Hole diameter
Number of holes
Hole spacing
Hole to end
Hole to outer edge
Corner chamfer
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: LO 9.
Notes
No published standard: each plate is its reference maker's design (ADR 0034). Blank: that plate's drawing doesn't use the symbol. Mark: sheet D02.
TITLE
'? CommunityCAD Size drawing, b8-I-4
STANDARDS FOLLOWED
No published standard (makers' drawings)
FAMILY / DETAIL
Extrusion joining plate - b8-I-4
SHEET
CC-JOINPLATE-SZ-b8-1-4 A 1.5:1
REV SCALE PROJECTION
UNITS
Dimensions in mm
SPEC VERSION
LICENSE
c964f fabe3a887708eb3e6e0cal8e3b2147b3b9c CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.