DIN 472 retaining ring for bores, normal type, 9 mm bore
Size drawing - 9 mm bore values on the views - enlarged 10:1
Sym. Dimensi
Ring thickness
Free diameter
Lug height (max)
Radial width at the back (~)
Plier hole (min)
Groove diameter
Groove width (H13)
Groove edge margin (min)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L19 - LO 1.
Notes
Sizes are the bore diameter d1; d3 is the ring's free outer diameter.
a max and d5 min are modeled at their limit; b is the standard's approximate value. The outline (taper, lugs, opening) is house construction, sheet D0O2.
d2, m, n: the bore groove, tabulated for your design, not modeled.
View from above
TITLE
'? CommunityCAD Size drawing, 9 mm bore
STANDARDS FOLLOWED FAMILY / DETAIL
DIN 472:2017-06 (superseded by DIN 472:2026-05) Retaining ring for bores - 9 mm bore SHEET REV SCALE PROJECTION UNITS CC-DIN472-SZ-9 A 10:1 € Dimensions in mm
SPEC VERSION LICENSE PAGE c964ffabe3a887708eb3e6e0cal8e3b2147b3b9c CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.