AC axial fan, die-cast frame, 80x38
Size drawing - 80x38 values on the views - scale 1:1
Sym. Dimensi
Frame side
Frame thickness
Hole spacing
Hole diameter
Flange thickness (open corners)
Width across flats (round frame)
dv Venturi (makers', not modeled)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L1 4 - LO 1.
Notes
No published standard: values are reconciled from makers' drawings (ADR 0034). - = wona square frame: only the round frame has flats.
dv: the makers' venturi bore, recorded only; the model's bore is sheet DO2's. Mounting holes run through t, through both flanges.
Rotor (bore, hub, struts, blades) is illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, 80x38
STANDARDS FOLLOWED FAMILY / DETAIL
No published standard (makers' drawings) AC axial fan - 80x38
SHEET REV SCALE PROJECTION UNITS CC-ACFAN-SZ-80x38 A 1:1 € Dimensions in mm SPEC VERSION LICENSE PAGE 54a208abf031c40a10474bFF4c55152d66ee5412 CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.