8 mm External Retaining Ring, DIN 471 datasheet (PDF)

Datasheet — 8 mm External Retaining Ring, DIN 471 by Milo

Open the PDF
8 mm External Retaining Ring, DIN 471Get the CAD model8 mm External Retaining Ring, DIN 471CC-DIN471-DS-8.pdf

Text of this datasheet

CC-DIN471-DS-8 revA Size datasheet - 8

'?) CommunityCAD

DIN 4718 external retaining ring

Size datasheet: this size's values with their levels, conventions and sources.

For a8 mm shaft Part key din471-d8 es | Files 1 STEP AP214 (simplified) 8, front view, 2.5:1 8, view from above, 1.5:1

Sym. Dimensi Value Level s Ring thickness 0.8 L1-4 d3 Free diameter 7.4 La: 4 a Lug height (max) < 3.2 L1-4 b Radial width at the back (=) 1.5 ref lil o & d5 Plier hole (min) >1.2 L1-4 d2 Groove diameter 7.6 Ll - 3 m Groove width (H13) 0.9 L1- 3 n Groove edge margin (min) > 0.6 L1- 3

Modeled value: nominal, else the midpoint of min-max. < / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.

DIN 471:2011-04 Page 1/2 Retaining ring for shafts - 8 - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec cfd05b053c736a4f15ba3030aa41f ebd40cdc205

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.

---

'?) CommunityCAD CC-DIN471-DS-8 rev A

Size datasheet - 8

Conventions « Values: s and d3 (the free inner diameter) at their nominals, the ring free (unstressed); a at its max and d5 at its min (single limits); b at its approximate value.

« Outline: An eccentric circle gives width b at the back and b/2 at the front; square lugs of side a with the d5 hole centred; a parallel opening b wide (sheet DO2).

« Lugs: Holed lugs at every size; no open hooks. « Edges, faces and markings: Sharp edges and joins, flat parallel faces, no markings. Material and finish are metadata only: one model per size. « Groove: The groove d2, m and nis tabulated for your design; it isn't modeled.

Sources

Source Publisher Retrieved sha256

fasteners-eu-din471 fasteners.eu 2026-10-26 14f4ce76d789

fasten-it-din471 fasten.it 2026-10-26 7b73cf8e9a50 he-maschinentechnik-din471 HC Maschinentechnik 2026-10-26 ef810e5b7ed0

seeger-din471 Seeger-Orbis n/a 57a47b2F6a0F (kept outside the repo)

The whole series (verification map, corrections, drawings): CC-DIN471-DS.

DIN 471:2011-04 Page 2/2 Retaining ring for shafts - 8 - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec cfd05b053c736a4f15ba3030aa41f ebd40cdc205

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.