Brushed DC can motor, can class, 775
Size drawing - 775 values on the views - enlarged 1.5:1
@B = 17.50
Sym. Dimensi
Can diameter
Body length
Shaft diameter
Front boss diameter
Front boss height
Rear boss diameter
Rear boss height
Mounting hole threat
Mounting hole spacii
42.3
67.0
90.0 refx
Overall length, not modeled
18.2
Shaft length from the mounting face
5.005 4.99-5.01
17.50
ing
Number of mounting holes
id
Largest diameter, end bell
Flux ring diameter, not modeled
TITLE
'? CommunityCAD
Size drawing, 775
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c =a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L111 - LO 3.
Notes
No published standard: each maker's drawing is its own lineage (ADR 0034).
Where makers differ, the largest stated (ADR 0134 row 4).
End cap, bell, vents, terminals and mark illustrative: sheet DO2.
STANDARDS FOLLOWED
Makers' drawings (Mabuchi, Johnson Electric, AndyMark)
; No published standard
FAMILY / DETAIL Brushed DC can motor - 775
SHEET REV
CC-DCMOTOR-SZ-775 A
SCALE
1.5:1
PROJECTION UNITS
Dimensions in mm
SPEC VERSION 06d85a52f6417d7ca3bac879661c871d1530757a
LICENSE CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use
the feedback section on the part page.