2.5-inch drive envelope, 7 mm
Size drawing - 7 mm values on the views - scale 1:1
xS2 = 90.60
H = 7.00 hs = 200 Fee —
ds = 3, ts = 2.00
db = 3, tb = 2.50
yb2 = 61.72
L = 100.20
yc = 30.125
xb1 = 14.0!
xb2 = 90.60
'? CommunityCAD
Sym. Dimensio!
Height, A1 (SFF-8201)
Width, A4; max A4 + A5
Length, Note 2; max A6
Length over the connector, A11 Side holes above the bottom, A23 End to the first side hole, A52
End to the second side hole, A53 Side to the bottom holes, A28 Bottom holes across, A29
End to the first bottom holes, ASO End to the second bottom holes, A51 Side hole thread M, A26
Bottom hole thread M, A32
Side full thread, A38 (min)
Bottom full thread, A41 (min) Lead-in , section 3's example Lead-in angle, section 3's example Connector width, A2 (SFF-8223) Datum B width, A3
Side to datum B, A13
Datum B centre off the centreline, A11 Connector centre height, A7 + A12 Connector height, AS
Connector past the end, A18
Datum C to the first bottom holes, A8
-Y side to the slot centre (computed, cb + cs / 2)
7.00
69.85
100.20
100.50 ref
3.00
> 2
3.75 ref 90 ref
42.73 ref
33.39 ref
13.43 ref
4.80
3.50 3.12-3.88 4.00 ref
0.30 ref
9.40
30.125
TITLE
Size drawing, 7 mm
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
</ = = the source gives only that limit, modeled at it. ref = reference. L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate. LO = one source only: printed amber and marked *.
c =a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L2 25.
Notes
Values are SFF-8201 Rev 3.4 Table 3-1 and SFF-8223 Rev 2.7 Table 3-1 (Option 1).
A dash: no such value. yc: computed from the rows, in the frame. Maxima (H, W, L): the envelope a mount must clear. The model is at the nominals.
STANDARDS FOLLOWED SFF-8201 Rev 3.4 - SFF-8223 Rev 2.7 (SNIA)
FAMILY / DETAIL
2.5-inch drive - 7mm
SHEET
CC-DRIVE25-SZ-7
REV SCALE
A 1:1
PROJECTION
UNITS
Dimensions in mm
SPEC VERSION
O2F48ec29F9e7bFFOEF75S6F4F5d939300beeeled
LICENSE
CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.