Arca-Swiss type quick release plate, 62 mm
Size drawing - 62 mm values on the views - scale 1:1
Sym. Dimensio!
Plate length (Leofoto, Sunwayfoto)
Plate thickness (one maker's)
Width as the makers state it, mm
alpha = 45.0° + 0.5° (flank) T = 12*
h = 4.826 Post-finish width at hg, in (RRS) 0.190 in
Dovetail width, in (RRS) 1.500
1.449 1.446-1.452
Flank angle, ° (RRS) 45.0 r=1.6
0.063 in wf = 36.805 at hg Flank angle as Acratech and ProMediaGear state it, ° 1.446 in-1.452 in
End view, 2:1 Gauge height, in (RRS, basic)
Side face height, in (RRS)
Dovetail height, in (RRS)
Bottom corner radius, in (RRS)
Clamping face flatness, in (RRS)
Slot width = 1/4-20 socket D (house) D = 6.35 house Counterbore width, 2.2 D (house)
Slot centres, L - 2c (house)
Mark side (house)
mark m = 7.325 house
From below (the clamping face)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how. i Hi Hy
House convention = a detail no source dimensions, drawn to a stated house rule. '? CommunityCAD Size drawing, 62 mm
This size's values: L2 8-L13-L01. STANDARDS FOLLOWED FAMILY / DETAIL
Notes RRS 1.5 in Dovetail Standard (maker drawing); no published standard Camera plate -62 mm
RRS values are its drawing's, in inches (x 25.4 mm): maker drawing, single lineage (L2). SHEET REV SCALE PROJECTION UNITS
wp agrees with w = 1.5 in within the makers' 38-39 mm rounding; it isn't modeled. CC-ARCASWISS-SZ-62 A 1:1 Dimensions in mm ap, the angle Acratech and ProMediaGear state, agrees with a within a's +0.5°; it isn't modeled. SPEC VERSION LICENSE PAGE
T is one maker's stated thickness (LO). Lengths: the plates both makers list (L1). 9325b178989ac5d161502b81caa4f9ee4cfda308 CC-BY 4.0 IronPixel Labs LLC 1/1 D, c, e, m: illustrative house rule (#1120 item 6 A), not any maker's design.
TITLE
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.