ISO 8752 slotted spring pin (roll pin), heavy duty, @6
Size drawing - @6 values on the views - | = 24 shown - enlarged 5:1
| = 24 shown lengths 10-100
Sym. | Dimensio
Wall thickness
Modeled bore (d1 - 2
Nominal diameter (the hole's, H12)
6.55 6.4-6.7
Outside diameter, before mounting
4.0 refc
Inside diameter, before mounting (ref)
End chamfer, axial length
Slot width mt (d1 max - d), clause 4
Double shear strength, min, kN
Modeled outside diameter (d1 midpoint)
s)
d3 Chamfer end diameter (d1 - s)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its mi)
in-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or
its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L16 - LO 1.
Notes
Modeled free, before mounting: the pin is larger than its hole (d, H12) by design. w: not specified by the standard; width from the clause 4 closing requirement.
'? CommunityCAD
TITLE
Size drawing, 96
‘STANDARDS FOLLOWED ISO 8752:2009
FAMILY / DETAIL
Spring pin - @6
SHEET REV
CC-1S08752-SZ-6 A
SCALE PROJECTION
5:1
UNITS
Dimensions in mm
SPEC VERSION e€79bc69C722a7450eb0be681b46a36c48d05506e
LICENSE CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.