DIN 705 adjusting ring (shaft collar), forms A and B, 6
Size drawing - 6 values on the views - form A shown - enlarged 5:1
Sym. Dimensi
Width, js14
d2 = 11.865 1173-12
View from above
d4 Pin hole, form B
di Bore, H8 (band middle)
d2 Outside, h13 (band middle)
Outside chamfer,
6
6.009 6-6.018
11.865 11.73-12
8
O1b
d3 Set-screw thread, form A
Ls Set-screw length, form A
Source levels
Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both. < / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or
its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate. LO = one source only: printed amber and marked *. c = a source value was corrected; the datasheet says how.
House convention = a deta This size's values: L16. Notes
il no source dimensions, drawn to a stated house rule.
d1, d2: the middle of the H8 / h13 band; grey = the band's limits (ISO 286-2).
c: the standard's drawn 0.1b x 45 deg, entered by the owner (#599), no source level. The views show form A. I_s: the screw's length, not modeled.
Form B: the same collar with a d4 hole in place of d3, through the near wall only.
'? CommunityCAD
TITLE
Size drawing, 6
STANDARDS FOLLOWED DIN 705:2019-03 (as tabulated) - ISO 286-2 (H8, h13) Shaft collar - 6
FAMILY / DETAIL
SHEET REV
CC-DIN705-SZ-6 A
SCALE PROJECTION
5:1
UNITS
Dimensions in mm
SPEC VERSION 946d39588085996aee8F621a618103eb3a8F37bd
LICENSE CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.