Brushed DC can motor, can class, 550
Size drawing - 550 values on the views - enlarged 1.5:1
Sym. Dimensi
35.8
Can diameter
Body length Sv)
75.0 refx Overall length, not modeled
Shaft length from the mounting face ZLOE
Shaft diameter 3.175
13.0
Front boss diameter
Front boss height
Rear boss diameter
Rear boss height
Mounting hole spacing
Number of mounting holes
Mounting hole thread
Dx Largest diameter, end bell
Source levels Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L110 - LO 3.
Notes
No published standard: each maker's drawing is its own lineage (ADR 0034). Where makers differ, the largest stated (ADR 0134 row 4).
End cap, bell, vents, terminals and mark illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, 550
STANDARDS FOLLOWED FAMILY / DETAIL Makers' drawings (Mabuchi, Johnson Electric, AndyMark); no published standard Brushed DC can motor - 550
SHEET REV SCALE PROJECTION UNITS
CC-DCMOTOR-SZ-550 A 1.5:1 € Dimensions in mm SPEC VERSION LICENSE PAGE 06d85a526417d7ca3bac879661c871d1530757a CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.