'?) CommunityCAD
CC-EN10056-DS-40x40x5 revA
Size datasheet - 40x40x5
40x40x5 equal leg steel angle
Size datasheet: this size's values with their levels, conventions and sources.
en10056 -40x40x5x100 ... (one per stock length) Files 6 STEP AP214 (simplified), one per stock length
Part keys
40x40x5, end view, 0.5:1
Sym. Dimensi
h Leg length
t Leg thickness
ri Root radius
r2 Toe radius 3.0c A Sectional area, cm? 3.79
Value
Level Li - 3 Li - 3 Li - 3 L1- 2 L1- 2
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected.
Level - independent sources.
EN 10056-1:2017 (through free tables) Equal leg steel angle - 40x40x5 - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
Page 1/2
spec 1fa02885ed33cc0e2d8b2F73686ba418650b8d17
---
. CC-EN10056-DS-40x40x5 rev A 0 CommunityCAD Size datasheet - 40x40x5
Lengths | Thread Part key
100 built - - en10056-40x40x5x100
250 built - - en10056-40x40x5x250
500 built - - en10056-40x40x5x500 1000 built - - en10056-40x40x5x1000 2000 built - - en10056-40x40x5x2000 6000 built - - en10056-40x40x5x6000
One STEP file per stock length.
Conventions
¢ Toe where r2 >= t: At 40x40x3, 45x45x3 and 50x50x3 the toe round has no end face to be tangent to: it leaves the inner face at its tangent point and runs out at the outer toe corner, so h and r2 both hold.
« Edges and tolerances: Sharp heel and outer toe edges. Nominal section: EN 10056 -2's rolling tolerances aren't modeled.
« Ends, lengths, finish: Flat ends square to the length, sharp edges (a sawn bar). The stock lengths as file options, length tolerance not modeled. No markings. Mid-grey mill scale with bright sawn ends, appearance only.
Sources
Source Publisher Retrieved sha256
roymech-en10056 Roymech 2026-10-30 OF7FF060e949
johnchorley-en10056 John Chorley (Steel Stockholders) 2026-10-30 95ca4F52e02e
arcelormittal-en10056 ArcelorMittal 2026-10-30 afO1falce4c5 (kept outside the repo)
The whole series (verification map, corrections, drawings): CC-EN10056-DS.
EN 10056-1:2017 (through free tables) Page 2/2 Equal leg steel angle - 40x40x5 - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec 1fa02885ed33cc0e2d8b2F73686ba418650b8d17
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.