Extrusion corner bracket, per profile system, s10-single
Size drawing - s10-single values on the views - enlarged 2.5:1
Sym. Dimensi
L Leg length
Upright leg length
Wall thickness
Upright wall thickness
Hole diameter
eens eee | 1
Number of holes
Key height
Hole row on the first leg
Hole row on the upright leg
ey Hole column from the side
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing).
L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: LO 11.
Notes
No published standard: each value the reference maker's drawing, single source (ADR 0034). Side walls, keys' width and length, fillet and mark are illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, s10-single
STANDARDS FOLLOWED FAMILY / DETAIL No published standard (makers' drawings) Extrusion corner bracket - s10-single
SHEET REV SCALE PROJECTION UNITS
CC-CORNBRKT-SZ-s10-single |A 2.5:1 & Dimensions in mm SPEC VERSION LICENSE PAGE 07a962633bdbeSé6céabcf253a98F14b1bbf3bd0F CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.