'?) CommunityCAD CC-CORNBRKT-DS-i8-single rev A
Size datasheet - i8-single
4O I-type slot 8 single corner bracket
Size datasheet: this size's values with their levels, conventions and sources.
4 For 40 |-type slot 8 aluminium extrusions Part key extrusion -corner- brackets -i8 - single | Files 1 STEP AP214 (simplified) i8-single, face, 0.5:1 i8-single, side, 0.5:1 (hidden lines dashed) Sym. Dimension Value Level 1 Leg length 4Ox lo - 1 h Upright leg length 4Ox* le@- 41 w Width 4Ox Lo - 1 ey Hole column from the side 20* lo- 1 ee Hole to leg end 20* lo - 1
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
No published standard (makers' drawings) Page 1/2 Extrusion corner bracket - i8- single - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec c7a962633bdbeSécéabcf253a98F14b1bbF3bdoF
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
'?) CommunityCAD CC-CORNBRKT-DS-i8-single rev A
Size datasheet - i8-single
Conventions
¢ Casting: Side walls of the wall thickness, an inside fillet, key width and length and, on the slot 10 and 45 brackets, a curved diagonal: illustrative, not any maker's design.
« Mark: The CommunityCAD mark recessed 0.3 mm in an outside side wall. Illustrative.
« Values: No published standard: every maker casts its own bracket, so each size is the reference maker's own casting (Misumi, OpenBuilds, item), single source. item's sheets give only the outline and holes: its wall and key are house proportions, its hole ISO 273 medium for M8. On the 20 B-type slot 6 double, Misumi's drawing alone shows which holes sit on its rows. The two readings disagreed, and the owner accepted this layout: 4 holes on the first leg in two rows, 2 on the upright in one, no centre column.
« V-slot holes: OpenBuilds' drawing gives the holes of the 20 V-slot bracket no position, so they sit at the middle of the leg and of the width, a rule rather than a maker's dimension.
¢ Finish: Cast aluminium, the reference part's finish: render and metadata only. First leg's profile face at Z = 0, the upright's at X = 0, the keys beyond them.
Sources Source Publisher Retrieved sha256 item-angle-brackets item Industrietechnik GmbH 2026-10-30 O5e0df30157e (kept outside the repo)
The whole series (verification map, corrections, drawings): CC- CORNBRKT-DS.
No published standard (makers' drawings) Page 2/2 Extrusion corner bracket - i8- single - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec c7a962633bdbeSécéabcf253a98F14b1bbF3bdoF
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.