ISO 2339 taper pin, 1:50, unhardened, 04
Size drawing - @4 values on the views - | = 16 shown - enlarged 10:1
Sym. | Dimensio Small-end diameter (h10) End dome, axial length
: Taper on diameter, 1:x Ja = 0.5 ref
Large-end diameter at | = 30 (d +1/ x)
Small-end dome radius (from d and a)
Source levels Main value = the modeled value (nominal, else the middle of min-max). Grey under a value = its min-max, where the source gives both. < / = = the source gives only that limit, modeled at it. ref = reference. L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate. LO = one source only: printed amber and marked *. c = a source value was corrected; the datasheet says how. House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L1 3. Notes d sits at its nominal: h10 puts the band below it, so the nominal is d max. =16 The large end is d + | / 50, so it grows with the length (the makers' formula). ls 16 shown Types A (ground) and B (turned) differ only in finish: one model for both.
[a = 0.5 ref
spherical dome
TITLE
'? CommunityCAD Size drawing, ®4
STANDARDS FOLLOWED FAMILY / DETAIL
ISO 2339:1986 Taper pin - 04
SHEET REV SCALE PROJECTION UNITS CC-1802339-SZ-4 A 10:1 € Dimensions in mm
SPEC VERSION LICENSE PAGE
e€79bc69C722a7450eb0be681b46a36c48d05506e CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.