4 mm E-clip, DIN 6799 size drawing (PDF)

Datasheet — 4 mm E-clip, DIN 6799 by Milo

Open the PDF
4 mm E-clip, DIN 6799Get the CAD model4 mm E-clip, DIN 6799CC-DIN6799-SZ-4.pdf

Text of this datasheet

DIN 6799 retaining washer for shafts (E-clip), 4 mm groove

Size drawing - 4 mm groove values on the views - enlarged 10:1 Sym. Dimensi Clip thickness Outer diameter, installed (max)

Groove diameter (the size)

Mouth width, loose (not modeled)

Shaft diameter range

Groove width

Groove edge margin (min)

Source levels

Main value = the modeled value (nominal, else the middle of min-max).

@d3 < 9.30 Grey under a value = its min-max, where the source gives both.

< / = = the source gives only that limit, modeled at it. ref = reference.

L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.

LO = one source only: printed amber and marked *.

c = a source value was corrected; the datasheet says how.

House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L17 - LO 2.

Notes

Sizes are the groove diameter d2; the clip is drawn and modeled installed in it. d3 max is modeled at its limit; a is the loose clip's mouth width, not modeled. The outline (lugs, pockets, jaws, arm ends) is house construction, sheet DO2. di, m, n: the shaft and its groove, tabulated for your design, not modeled.

View from above, installed

TITLE

'? CommunityCAD Size drawing, 4mm groove

STANDARDS FOLLOWED FAMILY / DETAIL DIN 6799:2017-06 Retaining washer for shafts (E-clip) - 4 mm groove

SHEET REV SCALE PROJECTION UNITS

CC-DIN6799-SZ-4 A 10:1 € Dimensions in mm SPEC VERSION LICENSE PAGE cfd05b053c736a4F15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.