4 mm Clevis Pin, ISO 2341, Form B size drawing (PDF)

Datasheet — 4 mm Clevis Pin, ISO 2341, Form B by Milo

Open the PDF
4 mm Clevis Pin, ISO 2341, Form BGet the CAD model4 mm Clevis Pin, ISO 2341, Form BCC-ISO2341-SZ-4.pdf

Text of this datasheet

ISO 2341 clevis pin with head, types A and B, 04

Size drawing - @4 values on the views - | = 16 shown - enlarged 5:1

Sym. | Dimensio

Shank diameter (h11)

Head diameter (h14) e=0.5 ref, B = 45° ref* (head chamfer)

Head height (js14)

Head chamfer, axial length

Underhead fillet radius

End chamfer, axial length, max

Split-pin hole, type B (H13)

|= 16 shown lengths 8-40 Hole axis to free end, type B, min

* Head chamfer angle from the axis, deg aS ref

ke End chamfer angle from the axis, deg 50 ref

End face diameter (d - 2 c tan a)

Head top face diameter (dk - 2 e tan B)

c <1, a = 30° ref* (end chamfer)

Source levels

Main value = the modeled value (nominal, else the middle of min-max).

Grey under a value = its min-max, where the source gives both.

< / = = the source gives only that limit, modeled at it. ref = reference.

L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.

LO = one source only: printed amber and marked *.

c = a source value was corrected; the datasheet says how.

House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L18 - LO 2.

Notes

c at its max and le at its min (single limits); d, dk, k, d1 at their nominals.

a, B: drawn only; one owner entry from the ISO 2341 figure (#604), so amber. Type A is type B without the hole; both are built for every length.

TITLE

'? CommunityCAD Size drawing, ®4

STANDARDS FOLLOWED FAMILY / DETAIL

ISO 2341:1986 Clevis pin - types A, B- @4

SHEET REV SCALE PROJECTION UNITS CC-1802341-SZ-4 A 5:11 € Dimensions in mm

SPEC VERSION LICENSE PAGE cfd05b053c736a4F15ba3030aa41febd40cdc205 CC-BY 4.0 IronPixel Labs LLC 1/1

Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.