GT2 timing pulley, 2 mm pitch, 6 mm belt, teeth and bore, 36t-8
Size drawing - 36t-8 values on the views - enlarged 4:1
36t-8 @dh = 17.1704
Pitch diameter (the belt's pitch line) 22.92
Outside diameter (the band) ca
Flange diameter 28.067
Face width between the flanges ToL
25k Width over the flanges 10.5
Overall length Bo
Hub diameter 17.1704
Set screw thread
* Gates' hub length (recorded) 7.5692
18* de Misumi's face diameter (recorded)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
@Odf = 28.067 c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L17 - LO 3.
Notes
Gates, Misumi and SDP/SI tables, each its own lineage (ADR 0034).
Largest stated where makers differ (ADR 0138 row 4); every maker's value on the page. Band a plain cylinder at da (no teeth); chamfers illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, 36t-8
STANDARDS FOLLOWED FAMILY / DETAIL
Gates' design manual, Misumi GPA 2GT and SDP/SI tables GT2 timing pulley - 36t-8
SHEET REV SCALE PROJECTION UNITS CC-GT2-SZ-36t-8 A 41 € Dimensions in mm
@da = 22.41 ‘SPEC VERSION LICENSE PAGE 7c5F93bb2a1674Fad1ed142d21F252056a66a74e CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.