NEMA hybrid stepper motor, frame x body length, 34x118
Size drawing - 34x118 values on the views - scale 1:1.33333
Body length (house)
Body square
Mounting hole spacing
Number of mounting holes
Through hole diameter 6.5
Pilot diameter 73.025
2.03 1.524-3.302
Pilot height
Shaft diameter Tol
Shaft length from the mounting face 37.18
74k Across the shaft's flat Tilof
Lf Flat length 25.4%
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule. This size's values: L18 - LO 3.
Notes
NEMA ICS 16 for frames 17, 23, 34; makers' drawings for the rest (ADR 0034). Body length: a house length backed by the makers (#1227 item 2 A).
Caps, stack, connector and label illustrative: sheet DO2.
TITLE
'? CommunityCAD Size drawing, 34x18
STANDARDS FOLLOWED FAMILY / DETAIL
NEMA ICS 16 Table 4 (frames 17, 23, 34) and makers' drawings NEMA hybrid stepper motor - 34x118 SHEET REV SCALE PROJECTION UNITS CC-NEMA-SZ-34x118 A 1:1.33333 € Dimensions in mm
SPEC VERSION LICENSE PAGE
O2F48ec29F9e7bFFOEF75S6F4F5d939300beeeled CC-BY 4.0 IronPixel Labs LLC 1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.