DIN 6799 retaining washer for shafts (E-clip), 3.2 mm groove
Size drawing - 3.2 mm groove values on the views - enlarged 10:1
@d3 <= 7.30
View from above, installed
ee
'? CommunityCAD
Sym. Dimensi
Clip thickness
Outer diameter, installed (max)
Groove diameter (the size)
Mouth width, loose (not modeled)
Shaft diameter range
Groove width
Groove edge margin (min)
Source levels
Main value = the modeled value (nominal, else the middle of min-max).
Grey under a value = its min-max, where the source gives both.
< / = = the source gives only that limit, modeled at it. ref = reference.
L2 = the standard itself (or its complete free preview, or the maker's drawing). L1 = two or more independent sources agree: the release gate.
LO = one source only: printed amber and marked *.
c = a source value was corrected; the datasheet says how.
House convention = a detail no source dimensions, drawn to a stated house rule.
This size's values: L17 - LO 2.
Notes
Sizes are the groove diameter d2; the clip is drawn and modeled installed in it. d3 max is modeled at its limit; a is the loose clip's mouth width, not modeled. The outline (lugs, pockets, jaws, arm ends) is house construction, sheet DO2. di, m, n: the shaft and its groove, tabulated for your design, not modeled.
TITLE
Size drawing, 3.2 mm groove
‘STANDARDS FOLLOWED DIN 6799:2017-06
FAMILY / DETAIL
Retaining washer for shafts (E-clip) - 3.2 mm groove
SHEET
CC-DIN6799-SZ-3.2 A 10:1
REV SCALE PROJECTION
UNITS
Dimensions in mm
SPEC VERSION
c964f fabe3a887708eb3e6e0cal8e3b2147b3b9c
LICENSE CC-BY 4.0 IronPixel Labs LLC
PAGE
1/1
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.