CC-FANGUARD-DS-30 revA Size datasheet - 30
'?) CommunityCAD
30 mm wire fan guard
Size datasheet: this guard's values with their levels, conventions and sources. Wire layout illustrative, not any maker's design; hole pattern, outside diameter, height and wire sizes from maker drawings.
Fits 30 mm square DC axial fans
Mounting 4 eyelets, 03.2 ona 24mm
Poor holes square Wire layout 2rings at 5.05 mm pitch, 4 ribs
(house rule, illustrative)
Part key fan-guards-30 30 mm, ring side, 0.75:1 30 mm, side view, 1:1 Files TSTEP AP214 (simplified) Sym. Dimension Value Level e Hole spacing 24 La - 2 dh Hole diameter (eyelet inside) 3.2 L1- 2 D Outside ring diameter 21.8% lo-1 h Height 4.8 La - 2 dring Ring wire diameter 1.6* lo- 4 drib Rib wire diameter 1.6* lo- 4
Modeled value: e and dh the reconciled nominal; D, h and the wire sizes the largest any maker states. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
No published standard (makers' drawings) Page 1/2 Wire fan guard - 30 mm - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec 304229b833a653b73db51178a38d40486ee7c36b
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
CC-FANGUARD-DS-30 revA Size datasheet - 30
'?) CommunityCAD
Conventions
e Illustrative rings: n flat round rings in one plane, centred on the axis, centrelines at radii i-p (i = 1..n), p = (D - dring)/2n; n the fewest that keep the clear gap p - dring at or under the 6.35 mm plug gauge the makers cite (UL 1/4 in). The innermost is the centre ring. Wire layout illustrative, not any maker's design; hole pattern, outside diameter, height and wire sizes from maker drawings.
« Ribs and wire planes: Four ribs on the diagonals, one per eyelet, from the centre ring out to the outer ring, then down to the eyelet, each bend round (radius one rib wire). The rings lie on top with their tops at h; each rib's top is on the rings' centre plane.
« Eyelets: Four flat round loops of the rib wire drib, inside diameter dh, their axes on a square of side e, lying on the mounting face (Z = 0). The loop shape is illustrative.
« Values: e and dh at their reconciled values from two or more makers' drawings (no published standard); D, h and the wire sizes the largest any maker states where they differ, so the model covers each maker's guard.
e Not modeled, finish: No side clips, weld beads, wire serrations, domed profile or markings. One solid, bright chrome; mounting face (against the fan) at Z = 0, ring tops at Z = h.
Sources
Source Publisher Retrieved sha256
qualtek-fan-guards Qualtek Electronics Corp. (FAN-S division) 2026-10-28 efOfab20a3ce (kept outside the repo) sepa-fan-guards SEPA Europe GmbH 2026-10-28 203138239b7F (kept outside the repo)
The whole series (verification map, corrections, drawings): CC-FANGUARD-DS.
No published standard (makers' drawings) Page 2/2 Wire fan guard - 30 mm - Dimensions in mm - CC-BY 4.0, IronPixel Labs LLC spec 304229b833a653b73db51178a38d40486ee7c36b
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
