CC-TNUTR-DS-b8-Mé rev A Size datasheet - b8-M6
'?) CommunityCAD
30 B-type slot 8 M6 roll-in spring T- slot nut
Size datasheet: this size's values with their levels, conventions and sources.
For 30 B-type slot 8 aluminium cy extrusions aa Part key slot-nuts -roll-in-b8-m6 O ! | Files 2 STEP AP214 (simplified, 4 threaded) b8-M6, top, 1:1 b8-M6, end, 2.5:1 (hidden lines dashed) Sym. Dimension Value Level w Body width across the slot 11.5 L1- 2 L Body length along the slot 17* Lo-1 b Neck width 7.8 L1- 2 h Overall height 6.8 L1- 2 k Body height 6.3% Lo-1 n Neck height 0.5 L1- 2 e Thread position from the near end 6x lo-41
Modeled value: nominal, else the midpoint of min-max. s / =: only that limit is given. * amber: one source (LO). c: a source value was corrected. Level - independent sources.
No published standard (makers' drawings) Page 1/2 Roll-in spring T-slot nut - b8-M6 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 396e2be9a0822407d28c83bfféfI9ab16e4601efc
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.
---
. CC-TNUTR-DS-b8-Mé revA '?) CommunityCAD Size datasheet - b8- M6
Conventions
¢ Flank and ball: The circular flank, and a chrome ball half the neck wide, standing proud of the bottom face by a tenth of the neck, in a blind hole between the thread and the far end. The spring isn't modeled. All illustrative, not any maker's dimensions.
+ Values: No published standard: each value the reference maker's drawing (Misumi). A second maker's value counts as agreeing where the slot leaves room for the difference, computed from the profile's data, and a size where a value stands on one maker is labelled single source.
e Fit: A nut is checked against its slot system's one-cell profile, never fitted to it: neck no wider than the opening, width no wider than the undercut, body no taller than the cavity.
« Finish: Brushed stainless: render and metadata only. No markings, no serrations, other edges sharp. Bottom face at Z = 0, the neck toward +Z.
Sources
Source Publisher Retrieved sha256
misumi-roll-in-nuts MISUMI 2026-11-02 4be34af734a5 (kept outside the repo) fath-roll-in-nuts FATH 2026-11-03 402664Fa2509 (kept outside the repo) pule-fath-roll-in-nut-heights CommunityCAD 2026-11-03 41¢9591e50de pule-misumi-roll-in-nut-neck CommunityCAD 2026-11-03 3ad399db61b4
The whole series (verification map, corrections, drawings): CC-TNUTR-DS.
No published standard (makers' drawings) Page 2/2 Roll-in spring T-slot nut - b8-M6 - Dimensions in mm - CC-BY 4.0, lronPixel Labs LLC spec 396e2be9a0822407d28c83bfféfI9ab16e4601efc
Modeled from cited sources; not certified. Found an error? Use the feedback section on the part page.